VidaBox Slim Guia de Instalação descarregar pdf (Página 11)

INSTALLATION

 Connect the TV Input

Depending on your TV provider source, you may connect the TV inputs in one of the

following ways:

 Do You Have a Set-top Box (STB)?

1. No – Go to Connecting Directly from a Coaxial Cable below

2. Yes – Go to How Many Set-top Boxes (STB’s) Do You Have?

Connecting Directly from a Coaxial Cable:

1. Take your incoming cable or satellite coaxial cable and plug it into the “In” Port of

the supplied 1-to-2 coaxial splitter.

2. Plug the output ends of the coaxial cable into the L TV Coaxial Input using the

included short coaxial jumper cables.

3.  Move on to the next section,  Connect the Video Output on page 12

 How Many Set-top Boxes (STB’s) Do You Have?

1. Two (2) – Connect the two (2) included IR blasters, as shown on the left, to the

back remote receiver. There are two inputs, marked  and . Place the IR

blasters/outputs over the IR receiver ports on each of the two STB’s. Go to

Connecting a Splitter below

2. Just One (1) – Connect one of the included IR blasters to back of the remote

receiver in the IR out port labeled . Then, place the blaster output over the IR

receiver ports of the STB.

After it is connected, go to  How Did You Connect to the Set-top Box (STB)?

Note: You can only watch or record one show at a time until you get another STB.

Connecting a Splitter:

1. Take your incoming coaxial cable and plug it into the “In” Port of the

supplied 1-to-2 coaxial splitter

2. Plug the 2 output coaxial cables into each cable or satellite input of the set-top

boxes (STB’s).

3. Move on to 

How Did You Connect the TV to the Set-top Box (STB)?

1-to-2 coaxial splitter



Looking for the

Next Section?

Look for this icon. It

denotes the start of a new

section

Included IR Blaster

Remote Receiver

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Sem comentários

VidaBox Slim Guia de Instalação Página 11